JVC DOME TYPE CAMERA TK-C676 - Manual (Page 40)

E-40
Other
Removing a Ceiling Flush Mount Bracket (Optional WB-S575)
Push the stopper release lever
upwards with a screwdriver, etc.
Release
label
*
Stoppers
Clamping
bracket
3.
4.
5.
6.
1.
Remove the ceiling panel.
Pull the ceiling panel and disengage the two hooks.
2.
Remove the camera.
Remove the camera from the Ceiling Mount by reversing the at-
taching procedure.
☞
P. 16, “Attaching the Camera”
3.
Loosen the clamping screws of the Ceiling Flush
Mount Bracket.
• Loosen the three clamping screws (by turning them counterclock-
wise).
• Make sure that the clamping brackets move inwards.
4.
Lower the Ceiling Flush Mount Bracket until the
stoppers contact the ceiling plate.
5.
Push up the stopper release lever, marked ( * ) in the
figure, using a screwdriver.
• While holding the Ceiling Flush Mount Bracket from below so that
it does not drop, push up the one of the three stopper release
levers marked (
* )using a screwdriver or a similar tool.
• If the ceiling plate is thick and the stoppers cannot be released
easily, push up two of the stopper release levers (including the
one marked (
* )).
6.
Pull out the Ceiling Flush Mount Bracket from the
hole in the ceiling.
Tilt the Ceiling Flush Mount Bracket and move it obliquely down-
ward to remove it.