JVC DOME TYPE CAMERA TK-C676 - Manual (Page 20)

E-20
Function & Setting
This adjusts the vertical synchronization to those of other cameras when a selector
switch for the synchronizing system on the Ceilling Mount is at LL. (50 Hz power
region only.)
When it is not set to LL, “---” will appear, disabling change the set value.
Setting values : –156 to 0 to 156
Sets the location of the position title and area title in the monitor.
UP
: At the top of the screen.
DOWN : At the bottom of the screen.
L : In the left half of the screen.
C : In the center of the screen.
R : In the right half of the screen
Setting values : UP-L, UP-C, UP-R, DOWN-L, DOWN-C, DOWN-R
When a tilting operation is started while this item is OFF, the camera will stop at the
position where it is pointing straight downwards. When an object moves directly
below the camera, the camera makes three movements
1 points the straight down-
ward 2 pans 180° 3 points upwards.
The FLIP function makes it possible to reduce these operations. Use this function
when monitoring an object passing directly below the camera.
OFF
: Turns the FLIP function off.
DIGITAL : Once the camera reaches a tilt of 135 degrees from horizontal after
passing a position facing directly downwards, a picture is inverted both
vertically and horizontally.
AUTO : When the camera reaches a position facing directly downwards, it pans
by 180° then stops.
Under this function, the panning and tilting speeds are adjusted automatically rela-
tive to the zoom ratio of the lens. Setting the zoom lens towards TELE decreases
the pan and tilting speeds.
Setting the zoom lens towards WIDE end increases the pan and tilting speeds.
Use this function when monitoring objects at differing zoom ratios.
OFF : Turns this function off.
ON : Turns this function on.
When this item is set to ON, the auto focusing (AF) is activated automatically dur-
ing manual pan/tilt and zoom operations.
This function is convenient when frequent manual operations are expected as it
eliminates the need to focus manually after every manual operation.
OFF : Turns this function off.
ON : Turns this function on.
When the zoom lens is set toward TELE, optical zooming is activated first and
electronic zooming second. This function sets the maximum zoom ratio of the
electronic zooming.
Setting values : x1, x2, x4, x6, x8, x10.
This function grays out sections that are not to be displayed in the monitored pic-
ture area.
The grayed out section moves accordingly when the camera is panned, tilted or
when the zoom is adjusted.
☞
P.29, “PRIVATE MASK Setup”
Setting Up the Camera Using an RM-P2580
CAMERA FUNCTION Screen
This screen sets up the functions of the camera itself.
Item
V. PHASE
POS. TITLE LOC.
FLIP
VAR. P/T SPEED
EASY AF
D. ZOOM MAX
PRIVATE MASK..
Initial Value
0
UP-L
DIGITAL
ON
OFF
x2
–
● Note Picture quality deteriorates under electronic zooming as it is accompanied by digital
image processing.
●
An increase in the electronic zooming ratio may deviate the center of the image slightly
toward the top left. This is due to the camera properties and is not a malfunction.
●
Continuous operation from optical zooming to electronic zooming is not available. When
optical zooming reaches the TELE end, press the TELE button again.
MEMO
Auto focusing may sometimes be incapable of bringing certain objects into accurate focus.
(
☞
P. 4)
In this case, use the manual focusing facility.
MEMO