beautypg.com

Turning analog direct on and off, Changing the source name, Analog direct – JVC LVT1007-010A[A] User Manual

Page 21: When changing the source name from “tv” to “dbs, When changing the source name from “tape” to “cdr

background image

19

Turning Analog Direct On and Off

You can enjoy the sound closer to the original source by overriding
the sound adjustments such as speaker output level adjustments (see
page 30), Digital Equalization (see page 30), Surround and DSP
modes (see pages 32 to 37), Bass Boost (see page 20) and Midnight
Mode (see page 18). You can only adjust the volume level while
Analog Direct is in use.
• Once you have made adjustment, it is memorized for each analog

source.

Press ANALOG DIRECT so that “A DIRECT” appears on the
display.

The lamp on the button also lights up.
• Each time you press the button, Analog Direct turns on and off.

Notes:

• When digital input mode is in use, Analog Direct is not available.
• Turning on Surround or DSP mode cancels Analog Direct and

previously selected sound adjustments are recalled.

• If Analog Direct is in use, Midnight Mode is temporarily canceled.
• Turning on Analog Direct cancels Input Attenuator (see page 18).

Changing the Source Name

When you have connected an CD recorder to the TAPE/CDR IN
jacks or a DBS tuner to the TV SOUND/DBS IN jacks on the rear
panel, change the source name which will be shown on the display.

When changing the source name from “TV” to “DBS”:

1. Press TV SOUND/DBS.

• Make sure “TV” appears on the display.

2. Press and hold TV SOUND/DBS until “ASSGN DBS”

appears on the display.

Note:

When connecting a DBS tuner to the TV SOUND/DBS IN jacks,
change the source name to “DBS,” which will be shown on the display
when selected as the source. Otherwise you cannot view any picture
from the DBS tuner.

When changing the source name from “TAPE” to “CDR”:

1. Press TAPE/CDR.

• Make sure “TAPE” appears on the display.

2. Press and hold TAPE/CDR until “ASSGN CDR” appears on

the display.

To change the source name to “TV” and “TAPE,” repeat the
same procedure above.

Note:

Without changing the source name, you can still use the connected
components. However, there may be some inconvenience.
– “TAPE” or “TV” will appear on the display when you select the CD

recorder or DBS tuner.

– You cannot use the digital input (see page 17) for the CD recorder.

VOLUME

LINEAR PCM

L

SUBWFR

R

ANALOG

SPEAKERS 1

Remote

NOT

RX-7032V

AUDIO/VIDEO CONTROL RECEIVER

ANALOG DIRECT

RX-7032V

AUDIO/VIDEO CONTROL RECEIVER

VOLUME

LINEAR PCM

L

SUBWFR

LS

RS

C

R

ANALOG

SPEAKERS 1

VOLUME

LINEAR PCM

L

SUBWFR

R

ANALOG

SPEAKERS 1

15-20_7032[A]3.pm6

03.5.12, 7:02 PM

19

This manual is related to the following products: