JVC HR-J435EK - Manual (Page 29)

29
6
q
1 2
4 5
3
6
8
0
7 9
1
3
2
NUMBER
OK
WEEKLY
TIMER
TIMER
CANCEL
START+/–
DAILY
TV PROG.
DATE+/–
PROG. CHECK
SP/LP
STOP+/–
SP/LP
ENTER PRESET POSITION
6
Press TV PROG. +/–.
SET TAPE SPEED
7
Press SP/LP to set the tape speed.
● If you’re not receiving PDC (Programme Delivery Control),
press NUMBER key “7” to set to "OFF" (
੬
pg. 30).
RETURN TO NORMAL
SCREEN
8
After confirming all information is correct, press OK
and the normal screen appears.
● Repeat steps 1 – 8 for each additional programme.
ENGAGE RECORDER’S
TIMER MODE
9
Press TIMER.
To Timer-Record Weekly Or Daily Serials . . .
. . . anytime during steps 2 through 8, press WEEKLY (NUMBER
key “9”) for weekly serials or DAILY (NUMBER key “8”) for
daily serials (Monday – Friday).
PROGRAM 1
START STOP
21 : 00 22 : 00
SP ON
DATE TV PROG
25. 12 1
BBC1
[+ –] : SET = : OK
SP
M D
7
7
9
6
8
NOTES:
● For safety, your recorder disables all other functions while in
the Timer mode. If you want to use the recorder but its Timer
mode is engaged, press TIMER and all other functions are
operable. To re-engage the timer, press TIMER.
● You can programme this recorder to timer-record as many as
8 programmes. If you try to programme the recorder to record
a ninth, "PROGRAM FULL" appears on screen and "FULL"
appears on the front display panel. To record the extra
programme, you must first cancel any unnecessary
programmes. (See "Check And Cancel Programmes" in the
right column.)
● To timer-record a satellite broadcast through a satellite
receiver connected to the AV2 IN connector on the back of
the recorder, in step 6 above, set "TV PROG" to "AUX2" by
pressing TV PROG. +/–. Before the selected programme
begins, select the appropriate channel on the satellite
receiver, then set the receiver's timer. If your satellite receiver
doesn't have a timer, leave the unit's power switched on.
ACCESS PROGRAMME
SCREEN
1
Press PROG CHECK. Each time you press the next
program’s information appears.
● Press OK and watch the front display panel as the
Start and Stop times, the Date and the Preset appear.
● If the recorder is turned on and the TV is set to its
VIDEO mode, you can check program information on
screen as well.
If All Information Is Correct . . .
. . . programming is completed.
If You Wish To Revise Data . . .
. . . with the recorder's power turned on, go to step 2.
If You Wish To Cancel A Program . . .
. . . . with the recorder's power turned on, press
CANCEL. All information you input is deleted.
REVISE PROGRAMME IN-
FORMATION
2
Input the appropriate data using the START +/–, STOP
+/–, DATE +/– and TV PROG. +/– buttons on the
remote control.
Check And Cancel Programmes