beautypg.com

Enter pluscode number, Enter preset position number, Close menu – JVC HR-J435EK User Manual

Page 25

background image

25

THE SATELLITE RECEIVER IS SHOWN CONNECTED TO THE
“AV2 IN” (SCART) CONNECTOR AND THE CABLE SYSTEM
CONNECTED VIA THE AERIAL SOCKET AND TUNED TO,
FOR EXAMPLE, PRESET POSITION 5 ON YOUR TV.

Cable

Satellite
Receiver

Cable
system

Satellite Antenna

TV Receiver

ENTER PLUSCODE NUMBER

4

Press OK, and a cursor
appears under “GUIDE
CH SET”. Then, using the
NUMBER keys, input the
PlusCode (found in most
TV listings) of a program
scheduled to be broadcast
on each station on the list
from step 1, starting at the
top. If you enter the wrong
number, press CANCEL and
input the correct number.

ENTER PRESET POSITION

NUMBER

4

5

Press OK and the display
under “TV PROG” begins
blinking.

If the blinking number
under “TV PROG” agrees
with the preset position . . .

. . . press OK.

If the numbers do not
agree . . .

. . . input the preset position using PUSH JOG

%fi or

the NUMBER keys, then press OK.

● If you input the PlusCode number of a program that

has already aired, “ERROR” appears on screen for a
few seconds. Input the correct PlusCode number.

● Repeat steps 4 and 5 as necessary.

CLOSE MENU

6

Press CH SET and selection is complete.

If you already know the Guide Channel number for a station . . .
1– After step 3, press PUSH JOG .

● ”GUIDE CH” begins blinking.

2– Enter the Guide Channel number using the NUMBER keys

or PUSH JOG

%fi, then press PUSH JOG .

● “TV PROG” begins blinking.

3– Enter the preset position using the NUMBER keys or

PUSH JOG

%fi, then press PUSH JOG .

● Repeat 2 and 3 as necessary.

4– Press CH SET.

NOTES:

If you own a satellite receiver, connect it to the AV2 connec-
tor on the back of the recorder. Then, in step 5 above, set the
input mode to "AUX2" by pressing NUMBER key "0" or TV
PROG.
+/–. Make sure no cables are connected to the front
panel connectors when performing this procedure.

If you’re receiving broadcasts via a cable box through preset
“5” (example) on your recorder, set “TV PROG” for “5” in
step 5.

After selecting the programme you wish to record from your
cable system or satellite receiver, set the system’s timer — if
your cable or satellite receiver does not have a timer, leave it
switched on.

GUIDE CH SET

12345 5

GUIDE CH

TV PROG

1

1

[0 – 9] : VIDEO PLUS +

: OK

When entering a
PlusCode for BBC 1

GUIDE CH SET

GUIDE CH

TV PROG

250

39

[

5∞] : SELECT

: OK

%

%

%