JVC HR-J435EK - Manual (Page 10)

10
1 2
4 5
3
6
8
0
7 9
1
3
2
6
q
INITIAL SETTINGS (cont.)
OK
PUSH JOG
CLOCK
RETURN TO NORMAL
SCREEN
4
Once clock setting is completed, press CLOCK to return
to the normal screen.
Manual Clock Set
SET DATE AND TIME
3
Press PUSH JOG %fi to set the hour, then press OK.
The “minutes” display begins blinking. Repeat the
procedure to set the minutes, day, month and year.
SET JUST CLOCK
4
The default setting is “ON”. Set as desired by pressing
PUSH JOG
%fi, then press OK.
● If you set to “OFF”, you can disregard the next step as
you won’t be able to receive regular clock adjust-
ments.
SET CLOCK DATA SOURCE
PRESET
5
The recorder is preset to receive clock setting and
adjustment data from preset position 1. Press PUSH
JOG
%fi to set the preset position to the number
representing the station transmitting clock setting data
(BBC1, BBC2, etc.), then press OK.
START CLOCK OPERATION
6
Press CLOCK.
NOTES:
● Just Clock (when set to "ON") enables adjustment of the
recorder's built-in clock every hour on the hour, except for 11
o'clock in the evening and midnight.
● Just Clock is not effective when . . .
– the recorder’s power is on (unless the recorder is tuned to
the same preset selected in the Clock Set screen).
– the recorder is in the Timer mode.
– a difference of more than 3 minutes exists between the
built-in clock’s time and the actual time.
● The recorder’s clock is automatically adjusted at the start/end
of Summer Time.
● Auto clock setting and Just Clock may not function properly
depending on the reception condition.
● During Manual clock setting, if the day and month data are
invalid (such as 31st April), the month digits are cleared
automatically and the day digits begin blinking. Input the
correct data.
● If, in step 3 of the Manual clock setting procedure, the year
digits are automatically cleared and the day digits begin
blinking, it is possible that you have input 29th February for a
non-leap year. Input the correct data.
6
3,4,
5
3,4,
5