JVC EX-D11 - Manual (Page 54)

8
Connecting AM loop antenna (supplied)
1
Set up the AM loop antenna.
2
Connect antenna cords.
3
Turn the AM loop antenna to the direction of the
best radio reception.
Locate the AM loop antenna as far away from
the main unit as possible.
• Do not locate the AM loop antenna on a metallic
table or close to a TV, personal computer, etc.
Otherwise it may result in bad radio reception.
7 When good radio reception cannot be obtained
with the supplied AM loop antenna
When positioning the antenna, find the best
position for reception while listen to an actual radio
program (refer to “Listening to a radio broadcast”
on page 31).
Connecting FM antenna (supplied)
7 When good radio reception cannot be obtained
with the supplied antenna or when using a
communal antenna
For details of connecting a separately sold
antenna, refer to the user guide for the antenna
or converter.
Connecting antennas
AM
EXT
AM
LOOP
Main unit (rear panel)
If the antenna
cord is covered
with vinyl on the
tip, twist and pull
the vinyl off and
remove.
Connect the end of the
antenna cord as shown
above.
AM
EXT
AM
LOOP
Extend an electric wire
horizontally, preferably
in a high place such as
above a window or
outdoors.
Connect the AM loop
antenna cords together with
the electric wire.
Main unit
(rear panel)
Electric wire
Twist
AM loop
antenna
Electric wire: 3 - 5 m (not supplied)
FM75 Ω
COAXIAL
Put the antenna up straight in the direction where
the best radio reception can be obtained, and fix
by using tape.
Main unit
(rear panel)
FM antenna
FM75 Ω
COAXIAL
Antenna cord (not
supplied) Communal
antenna terminal
Outdoor FM
antenna
(not supplied)
Coaxial cable
(not supplied)
Converter
(not supplied:
compatible with
300
Ω/75 Ω)
Main unit
(rear panel)
Depending on the radio reception
conditions, an FM feeder antenna (not
supplied: compatible with 300
Ω) can be
used. In the case, a converter (not
supplied) is required.
or
Connecting up
– Do not turn on the power until the connection is complete –
EX-D11[U].book Page 8 Tuesday, May 30, 2006 4:13 PM