JBL CONTROL NOW AW - Manual (Page 7)

English
7
4. The mounting bracket is designed to trap the fl ange of the JBL Control NOW
speaker by securing the mounting-bracket cap with two screws through the
bottom of the mounting bracket. Rest the JBL Control NOW speaker’s rear
fl ange in the mounting bracket, as shown. This will support the weight of the
speaker. Now slide the mounting-bracket cap over the assembly. Secure the
mounting-bracket cap by inserting two #10-32 x 2" (M5 51 mm) screws (pro-
vided) in the bottom of the mounting bracket and tightening.
Mounting-Bracket Cap
Mounting Bracket
#10-32 x 2" (M5 51 mm) Screws (2)
(side view)
(side view)
Mounting Bracket
shown as looking through
the speaker.
Top Cap
Mounting Bracket
Ceiling line
#10-32 x 2"
(M5 51 mm)
5. To orient the JBL logo into the correct position, pull the JBL logo slightly
outward from the speaker grille and rotate. The JBL logo is held in place by
a spring. Peel the adhesive cover off the mounting-bracket cover and attach
to bottom of mounting assembly.
Mounting-Bracket Cover