beautypg.com

JBL CONTROL NOW AW User Manual

Page 24

background image

2-CHANNEL STEREO WIRING

1. Use the stereo sound-distribution connection for a smaller home theater/stereo

environment. Run the sets of paired wires out two opposite wire access holes
through the pole-mount bracket, as shown.

NOTE: This procedure is applicable for both large- and small-diameter
drop tubes. A large-diameter drop tube is shown here.

Pole-Mount-Bracket

Cap

Drop Tube

Pole-Mount

Bracket

Wire Access Holes

2-Channel-wiring for stereo sound distribution.

2. Remove the terminal assemblies from the rear of all four speakers. The terminal

assembly is removed by rotating it slightly counterclockwise, as shown.

Use the transparent plastic strap to pull the terminal assembly out, as shown.

3. Connect the small end of the multiunit wiring adapter to the rear of speakers

D and B, as shown.

4. Place speakers D and B with connectors attached on the pole-mount bracket,

as shown. Run the wiring for the multiunit wiring adapter through the wire
access holes, as shown.

Multiunit Wiring Adapter

to connect to speaker

C

Multiunit Wiring Adapter

to connect to speaker

A

Pole-Mount-Bracket Cap

Drop Tube

Pole-Mount Bracket

Wire Access

Holes

Connector

Connector

D

B

5. Slide the large end of the multiunit wiring adapter that is already attached

to speaker B into the rear of speaker C at a slight angle and rotate clockwise,
as shown.

This end is connected to speaker

B.

6. Connect the terminal assembly to the back of the multiunit wiring adapter. It

will snap securely into place.

This end is connected to speaker

B.

24