JBL CONTROL NOW AW - Manual (Page 14)

3/4-ROUND WALL-MOUNTING
CAUTION
The customer is responsible for proper selection and use of mounting hardware
(available through hardware stores), to properly and safely wall-mount the
speakers. The JBL Control NOW speaker was designed to be easily installed.
However, if you are unable to clearly and fully understand and follow the
instructions in this manual, or if you are unsure of your ability to properly install
these loudspeakers, please contact your dealer or a qualifi ed installer. Please
do not use any power tools during installation. Power tools can exert excessive
and unnecessary torque which, in turn, can damage fasteners or other parts
and accessories, reducing their strength and causing possible failure of the
fastener or part. A failed or damaged fastener or part may not be able to
perform as designed, and may lead to an unsafe installation.
1. Secure three corner/wall-mounting brackets together by using four
#10-32 x 1/2" (M5 13 mm) screws provided as shown.
#10-32 x 1/2" (M5 13 mm)
Screws (2)
#10-32 x 1/2" (M5 13 mm)
Screws (2)
When deciding upon a location for the JBL Control NOW speaker, take care
NOT to install the mounting bracket closer than 3" (7,6 cm) to the ceiling. Any
closer than 3" (7,6 cm) will not allow the room needed to position and slide the
JBL Control NOW speaker into the mounting bracket.
ceiling
3" (7,5 cm) Minimum
distance from ceiling
to top of bracket
(horizontal mounting)
2. Attach the mounting bracket to the wall. Be sure to use appropriate anchors.
Appropriate
anchors
3. Remove the terminal assemblies from the rear of all speakers. The terminal
assembly is removed by giving it a slight counterclockwise rotation. Use the
transparent plastic strap to pull the assembly out, as shown.
14
Speaker 1
Speaker 2
Speaker 3