JBL CONTROL NOW AW - Manual (Page 17)

English
17
STAND-MOUNTING
IMPORTANT SAFETY NOTE:
CAUTION
The supplied fl oor stand adapters facilitate installation with a variety of general-
purpose fl oor stands available from many manufacturers. Since different stands
will have different weight capacities and stability characteristics, it is the
customer’s responsibility to check with the stand manufacturer or dealer to
ascertain whether that specifi c stand is capable of handling the weight and
proportions of these loudspeakers in a safe and stable manner. JBL, Inc.,
disclaims any liability for the selection of suitable fl oor stands and/or correct
compatibility between the selected stand and the supplied stand adapter.
1. Attach the stand-mounting bracket
to the stand with the #1/4-20 x 1"
(M6 25 mm) screw as shown.
2. Run the wiring as shown.
3. Place the JBL Control NOW speaker
on the stand-mount bracket and
stand, as shown.
4. Use two #8-32 x 1/2" (M4 13 mm)
screws provided to secure the JBL
Control NOW speaker to the stand.
5. Attach wires.
IMPORTANT: Make sure all equipment is turned off before making
any connections. For speaker connections, use a high-quality speaker wire
with polarity coding. The side of the wire with a ridge or other coding is
usually considered positive polarity (i.e., +).
NOTE: If desired, consult your local JBL dealer about speaker wire and
connection options.
RED = +
BLACK = —
1. Strip 1/4" (6 mm) of wire
2. Press and push connector
3. Insert bare end;
release push connector
The speakers have coded terminals that
accept a variety of wire connectors. The most
common connection is shown in the diagram
to the left. To ensure proper polarity, connect
each + terminal on the back of the amplifi er
or receiver to the respective + (red) terminal
on each speaker, as shown. Connect the
– (black) terminals in a similar way. See
the owner’s guides that were included with
your amplifi er, receiver and television to
confi rm connection procedures.
IMPORTANT: Do not reverse polarities (i.e., + to – or – to +) when making
connections. Doing so will cause poor imaging and diminished bass response.
RED = +
BLACK = —
Standard
Connection
Wiring diagram shows
polarity connections for
one channel of a stereo or home theater system.
An alternate orientation
shown here.
Stand
Stand-Mount Bracket
(M6 25 mm)
#1/4-20 x 1"
(M4 13 mm)
Screw Provided
Note trough in Stand-Mount
Bracket for
cable management.
#8-32 x 1/2" Screws