JVC KD-SX959R - Manual (Page 16)

16
ENGLISH
Other convenient RDS functions and adjustments
Automatic selection of the station when using the number
buttons
Usually when you press the number button, the preset station is tuned in.
However, when the preset station is an RDS station, something different will happen. If the
signals from that preset station are not sufficient for good reception, this unit starts searching
another station broadcasting the same programme as the original preset station is broadcasting,
then if any station broadcasting the same programme is found, the station will be tuned in.
Changing the display mode while listening to an FM
station
You can change the initial indication on the display to either station name (PS) or to station
frequency, while listening to an FM RDS station.
• See also “Changing the general settings (PSM)” on page 28.
1 Press and hold SEL (Select) for more than 2 seconds so that “PSM” appears on the lower
part of the display.
2 Select “TU DISP (Tuner Display)” with ¢ or 4 .
3 Set to the desired indication (either station name or station frequency) with the control dial.
Note:
By pressing DISP, you can also change the display while listening to an FM RDS station.
Each time you press the button, the following information appears on the upper part of the display:
* Then, the display goes back to the original indication in several seconds.
Setting the TA volume level
You can preset the volume level for TA Standby Reception. When a traffic programme is
received, the volume level automatically changes to the preset level.
• See also “Changing the general settings (PSM)” on page 28.
1 Press and hold SEL (Select) for more than 2 seconds so that “PSM” appears on the lower
part of the display.
2 Select “TA VOL (Volume)” with
¢
or
4
.
3 Set to the desired volume with the control dial.
Station Frequency PS (Station name) PTY (Program type)
EN10-17.KD-SX999R[E]/1 98.12.8, 0:56 PM 16