Using the remote control unit, Cont.) – JVC GR-DVL365 User Manual

Page 60

SELECT SCENES

Point the remote control at the camcorder’s

remote sensor. Press PLAY (4) and then press
R.A.EDIT ON/OFF on the remote control.
The Random Assemble Editing Menu appears.

If using a Fade/Wipe at the beginning of the

scene, press FADE/WIPE on the remote control.
• Cycle through the effects by pressing repeatedly,

and stop when the one you want is displayed.

At the beginning of the scene, press EDIT IN/

OUT on the remote control. The Edit-In position
appears in the Random Assemble Editing Menu.

At the end of the scene, press EDIT IN/OUT. The

Edit-Out position appears in the Random Assemble
Editing Menu.

If using a Fade/Wipe at the end of the scene,

press FADE/WIPE.
• Cycle through the effects by pressing repeatedly,

and stop when the one you want is displayed.

• If you select a Fade/Wipe effect for an Edit-Out

point, the effect is automatically applied to the
following Edit-In point.

• When you use Fade/Wipe effects, that time is

included in the total time.

If using Playback Special Effects, press EFFECT

(

੬

pg. 56).

Repeat steps 6 through 9 to register additional

scenes.
• To change previously registered points, press

CANCEL on the remote control. The registered
points disappear, one at a time, from the most
recently registered point.

• If you are not using Fade/Wipe or Programme AE

with special effects, repeat steps 6 and 7 only.

NOTES:

● When choosing a scene, set Edit-In and Edit-Out points so that there is a relatively large difference between them.

● If the search time for an in-point exceeds 5 minutes, the recording deck’s Record-Standby mode will be cancelled and

editing will not take place.

● If there are blank portions before or after the Edit-In and Edit-Out points, a blue screen may be included in the edited

version.

● Since time codes register time only as accurately as seconds, the time code total time may not match the total

programme time exactly.

● Turning off the camcorder’s power erases all registered Edit-In and Edit-Out points.

● If you select Sepia or Monotone mode from Programme AE with special effects, you cannot use the Black & White

Fader. In this case the Black & White indicator begins blinking. Once the next Edit-In point is registered, the effect is
turned off. To combine these effects, use Sepia or Monotone during recording, then use the Black & White Fader
during Random Assemble Editing.

● It is not possible to use Fade/Wipe effects and Programme AE with special effects during Random Assemble Editing

using a DV cable.

USING THE REMOTE CONTROL UNIT

(cont.)

2
3
4
5
6
7
8

– – : – – ~

~
~
~
~
~
~
~

– – : – –

0 : 00

– –

TOTAL

CODE

T I ME

OUT

MODE

PLAY

R.A.EDIT
ON/OFF

EFFECT

FADE/WIPE

EDIT IN/OUT

CANCEL

REW

Random Assemble
Editing Menu

Programme

Remote sensor