JVC GR-DVL365 - Manual (Page 48)

48
EN USING MENUS FOR DETAILED ADJUSTMENT
(cont.)
: Factory-preset
Menu Screen Explanations (cont.)
NOTES:
● The “
MANUAL” settings are effective only when the Power Switch is set to “ MANUAL ”.
● “
SYSTEM” functions which are set when the Power Switch is set to “ MANUAL ” are also applied when the Power
Switch is set to “PLAY” (
੬
pg. 50).
Usually the distance to a subject where the lens is in focus depends on the
zoom magnification. Unless there is a distance more than 1m to the subject,
the lens is out of focus at the maximum telephoto setting. When set to “ON”,
you can shoot a subject as large as possible at a distance of approx. 60 cm.
• Depending on the zoom position, the lens may go out of focus.
Records with no change in the screen ratio. For playback on a TV with a
normal screen ratio.
Inserts black bands at the top and bottom of the screen. During playback on
wide-screen TVs, the black bands at the top and bottom of the screen are cut
and the screen ratio becomes 16:9.
appears. When using this mode, refer
to your wide-screen TV’s instruction manual. During playback/recording on 4:3
TVs/LCD monitor/viewfinder, black bands are inserted at the top and bottom of
the screen and the image appears like a letterboxed 16:9 movie.
• The “CINEMA” mode is effective only when the VIDEO/MEMORY Switch is
set to “VIDEO” (GR-DVL867/DVL865/DVL767/DVL765/DVL567/DVL367/
DVL365 only).
For playback on TVs with an aspect ratio of 16:9. Naturally expands the image
to fit the screen without distortion.
appears. When using this mode, refer to
your wide-screen TV’s instruction manual. During playback/recording on 4:3
TVs/LCD monitor/viewfinder, the image is elongated vertically.
• The “SQUEEZE” mode is effective only when the VIDEO/MEMORY Switch is
set to “VIDEO” (GR-DVL867/DVL865/DVL767/DVL765/DVL567/DVL367/
DVL365 only).
“ ” appears. The zoom range is extended beyond the maximum optical zoom
wide angle range. This mode’s wide angle setting is equivalent to using a 0.9X
wide conversion lens. Zooming is possible from 0.9X to 10X. This mode is
suitable for shooting in a small room.
• “S.WIDE” mode is effective only when the VIDEO/MEMORY Switch is set to
“VIDEO”.
Disengages the function which cuts down on noise created by wind.
Helps cut down on noise created by wind. “ ” appears. The quality of the
sound will change. This is normal.
Even though not heard while shooting, shutter sound is recorded on the tape.
The beep sounds when the power is turned on or off, and at the beginning and
end of recording. Also to activate the shutter sound effect (
੬
pg. 26, 42).
Instead of a beep, a melody sounds when any operation is performed. It also
activates the shutter sound effect (
੬
pg. 26, 42).
The tally lamp remains off at all times.
The tally lamp comes on to signal the start of recording.
This number is necessary when connecting the camcorder to a device such as
a computer using the J terminal (JLIP) or PC connector. The numbers range
from 01 to 99. Factory setting is 06.
TELE
MACRO
WIDE
MODE
WIND
CUT
BEEP
TALLY
ID NUMBER
OFF
ON
OFF
CINEMA
SQUEEZE
S.WIDE
OFF
ON
OFF
BEEP
MELODY
OFF
ON
(GR-DVL867/
DVL865/
DVL767/
DVL765 only)
(GR-DVL167/DVL160 only)
SYSTEM
MANU
AL