JVC GR-DVL365 - Manual (Page 40)

40
EN
IMPORTANT
Some Fade/Wipe Effects cannot be used with certain
modes of Programme AE with special effects
(
੬
pg. 38, 39). If an unusable Fade/Wipe Effect is
selected, its indicator blinks or goes out.
Fade/Wipe Effects
These effects let you make pro-style scene transi-
tions. Use them to spice up the transition from one
scene to the next.
Fade or Wipe works when tape recording is started
or when you stop recording.
1
Set the VIDEO/MEMORY Switch to “VIDEO”
(GR-DVL867/DVL865/DVL767/DVL765/DVL567/
DVL367/DVL365 only), then set the Power Switch to
“
MANUAL ” while pressing down the Lock Button
located on the switch.
2
Press the MENU/BRIGHT wheel in. The Menu
Screen appears.
3
Rotate the MENU/BRIGHT wheel to select “
WIPE/FADER”, then press it.
4
Rotate the MENU/BRIGHT wheel to select the
desired function, then press it. Selection is complete.
Press the MENU/BRIGHT wheel in again.
• The WIPE/FADER Menu disappears and the effect
is reserved. The indicator representing the selected
effect appears.
5
Press the Recording Start/Stop Button to activate
the Fade-in/out or Wipe-in/out.
To Deactivate The Selected Effect . . .
..... select “OFF” in step 4.
NOTE:
You can extend the length of a Fade or Wipe by pressing
and holding the Recording Start/Stop Button.
FOR RECORDING
(cont.)
Recording Start/Stop Button
MENU/BRIGHT Wheel
Power Switch
VIDEO/MEMORY Switch
(GR-DVL867/DVL865/DVL767/DVL765/
DVL567/DVL367/DVL365 only; open the
LCD monitor to access this switch.)
Lock Button