Jacuzzi J - LXL - Manual (Page 48)

44
LX Collection
To correct condition:
Remove the spa's cover and allow your spa to cool down. •
Program the filter settings for Economy Mode (page • 30). Raise water
temperature setting to cancel Summer Logic condition (page 42).
If the condition persists, contact your authorized Jacuzzi dealer. •
14.8 panel Displays (- - -)
warnInG:
rIsK oF HYperTHermIa (over-HeaTInG)
Causing severe inJury, burns, or welts.
!
Water temperature is above acceptable limits. Do noT
enTer spa! The safety “Watchdog” software has been
triggered and the spa is deactivated. A problem has been
detected which could cause damage to the spa or its components.
Contact your authorized Jacuzzi dealer or qualified service technician.
15.0 troubleshooting Procedures
In the event your Jacuzzi spa is not working the way it should, please
first review all the installation and operating instructions in this manual
and check for messages on the panel display. If you are still not satisfied
it is working properly, please follow the appropriate troubleshooting
instructions below.
note: If any of the supply cords to accessories are damaged, they must
be replaced by authorized service personnel. Contact your authorized
Jacuzzi dealer or qualified service technician.
15.1 none of the Components operate (e.g. Pump, light)
Check the following:
1. Is there power to the spa?
2. Is the household circuit breaker tripped?
3. Contact your authorized Jacuzzi dealer or qualified service
technician.
15.2 pump Does not operate But light Does
Press the JETS 1 button:
If no water movement is detected, make sure power is going to the spa
and check the water level. If this does not solve the problem, contact
your authorized Jacuzzi dealer or qualified service technician.
The main jets pump 1 operates but no water flows to jets. Check the
following:
1. Jets may all be closed. Verify all jets are in the open “on” position
(Sec. 10.5, page 28).
2. Pump may not be properly primed. This can happen after the spa is
drained and refilled. Press the JETS 1 button on the control panel