beautypg.com

Jacuzzi J - LXL User Manual

Page 20

background image

16

LX Collection

ImporTanT: Always fill your spa through the filter bucket after

draining. Failure to do so may cause air to be trapped in either

pump, preventing the pump from circulating water. Remove the

hose and replace the filter cartridge. Note: DO NOT overtighten

filter cartridge, finger tight only!

3.

Turn on power

Turn on power to spa at the home’s circuit breaker to start boot

up sequence (Sec. 10.0, page 27). The heater and filter pump will

automatically activate after several seconds. If the control panel LED

flashes water temperature and “COL” or “ICE” this is normal, refer to

page 42 for additional information.

4.

activate Jets pumps

Turn on jets pump(s) to ensure proper mixing when adding

start-up chemicals in step 5.

5.

add start-up Chemicals

Add the spa water chemicals as recommended by your authorized

Jacuzzi dealer. See Section 13.0 “Water Quality Maintenance” (page 40)

for general guidance.

warnInG:

rIsK oF poIsonInG or DeaTH.

Never leave chemicals opened and accessible to anyone. Use

chemicals according to the vendors instructions. Always store

chemicals in a safe and/or locked location. Keep away from

and out of reach of children.

!

6.

establish a stable sanitizer reading

Establish a stable sanitizer reading between 3.0-4.0 ppm chlorine or 2.0-

4.0 ppm bromine. To ensure healthy water conditions, always maintain

a constant sanitizer reading within the levels recommended by the

Association of Pool and Spa Professionals/USA printed on the inside

cover of this manual. If sanitizer levels cannot be stabilized, perform the

decontamination procedure steps 9-16 on pages 17-19.

note: The “decontamination procedure” steps 9-16 should also be used

after the spa has been “Winterized” (Section 12.9 page 39) or has been

sitting without power for an extended period.

7.

set spa To Heat

To warm spa water to a comfortable temperature, follow

these steps:

The LED display on the control panel displays the actual temperature

of the spa water. Press either the

Cooler ( ) or warmer

( ) button once to display the “set” temperature for 5 seconds. If

you want the water to heat to a different temperature, simply press

Cooler ( ) or warmer ( ) within 5 seconds. The set

2

1

This manual is related to the following products: