JVC LYT0633-001A - Manual (Page 7)

EN
7
1
2
To battery
pack mount
To DC OUT
terminal
To AC outlet
AC Power
Adapter/
Charger
DC cord
ATTENTION:
Before detaching the power source,
make sure that the camcorder’s power
is turned off. Failure to do so can result
in a camcorder malfunction.
USING THE BATTERY PACK
1
Insert the terminal end 1 of the battery pack into the
battery pack mount, then firmly push the end 2 of
the battery pack in the direction of the arrow until it
locks into place as shown in the illustration.
•If the battery pack is attached in the wrong position,
a malfunction may occur.
To Detach The Battery Pack . . .
.... while sliding down BATT. RELEASE, detach it.
Power cord
Approximate recording time
BATT. RELEASE
Switch
NOTES:
● Recording time is reduced significantly under the
following conditions:
•
Zoom or Record-Standby mode is engaged repeatedly.
• The LCD monitor is used repeatedly.
• The playback mode is engaged repeatedly.
● Before extended use, it is recommended that you
prepare enough battery packs to cover 3 times the
planned shooting time.
USING AC POWER
Use the AC Power Adapter/Charger (connect as shown in
the illustration).
NOTES:
● The provided AC Power Adapter/Charger features
automatic voltage selection in the AC range from 110 V
to 240 V.
● For other notes,
੬
pg. 6.
INFORMATION:
VU-V856KIT is a set composed of the
BN-V856U battery pack and AA-V80EG or
AA-V80EK AC Power Adapter/Charger.
Read the VU-V856KIT’s instruction manuals
before using.
It is impossible to charge the BN-V856U battery
pack using the provided AC Power Adapter/
Charger. Use the optional AA-V80EG or
AA-V80EK AC Power Adapter/Charger.
Battery pack
BN-V507U
BN-V514U
(optional)
BN-V856U
(optional)
LCD monitor on/
Viewfinder off
55 min.
1 hr. 50 min.
7 hrs. 30 min.
LCD monitor off/
Viewfinder on
1 hr. 5 min.
2 hrs. 10 min.
9 hrs.