beautypg.com

Troubleshooting, Symptom possible causes corrective action – JVC LYT0633-001A User Manual

Page 56

background image

56

EN

SYMPTOM

POSSIBLE CAUSES

CORRECTIVE ACTION

TROUBLESHOOTING

1. No power is supplied.

2. “SET DATE/TIME!”

appears.

3. Recording cannot be

performed.

4. There is no picture.

5. Some functions are not

available using the MENU
wheel.

1. •The power is not connected

properly.

•The battery is dead.
•The LCD monitor is not

open fully or the viewfinder
is not pulled out when
recording.

2. •The built-in clock’s

rechargeable lithium battery
is discharged.

•The previously set date/time

is erased.

3. •The tape’s erase protection

tab is set to “SAVE”.

•The POWER Switch is set to

” or “OFF”.

•“TAPE END” appears.
•The cassette holder cover is

open.

4. •The camcorder is not getting

power, or some other
malfunction exists.

5. •The Operation Switch is set

to “

”.

1. •Connect the AC Power

Adapter/Charger securely
(

pg. 7).

•Replace the dead battery

with a fully charged one
(

pg. 6, 7).

•Open the LCD monitor fully

or pull out the viewfinder.

2. •Connect the camcorder to

an AC outlet using the AC
Power Adapter/Charger for
over 24 hours to charge the
clock’s lithium battery
(

pg. 9).

3. •Set the tape’s erase

protection tab to “REC”
(

pg. 10).

•Set the POWER Switch to

” (

pg. 12).

•Replace with new cassette

(

pg. 10).

•Close the cassette holder

cover.

4. •Turn the camcorder’s power

off and on again (

pg. 14).

5. •Set the Operation Switch to

” (

pg. 12).

If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.

The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio,
etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery
pack, AC Power Adapter/Battery Charger, etc.) and wait a few minutes; and then re-connect it and proceed
as usual from the beginning.