JVC LYT0633-001A - Manual (Page 62)

62
EN
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
40. An error indication
(E01 — E06) appears.
41. The charger indicator on
the AC Power Adapter/
Charger does not light.
42. Picture does not appear on
the LCD monitor.
43. When the image is printed
from the printer, a black
bar appears at the bottom
of the screen.
44. When the camcorder is
connected via the DV
connector, the camcorder
does not operate.
45. During transport, the lens
cover opens.
40. •A malfunction of some kind
has occurred. In this case
the camcorder’s functions
become unusable.
41. •The temperature of the
battery is extremely high/
low.
•Charging is difficult in
places subject to extremely
high/low temperatures.
42. •The viewfinder is pulled
out.
•The LCD monitor's
brightness setting is too
dark.
43. •This is not a malfunction.
44. •The DV cable was plugged/
unplugged with power
turned on.
45.
————
40. •Remove the power supply
(battery pack, etc.) and wait
a few minutes for the
indication to clear. When it
does, you can resume using
the camcorder.
If the indication remains
even though you repeat the
above two or three times,
please consult your nearest
JVC dealer.
41. •To protect the battery, it is
recommended to charge it
in places with a temperature
of 10°C to 35°C (
੬
pg. 69).
42. •Push the viewfinder back in.
•Adjust the brightness of the
LCD monitor (
੬
pg. 14).
•If the monitor is tilted
upward 180 degrees, open
the monitor fully (
੬
pg. 14).
43. •By recording with “DIS”
activated (
੬
pg. 24) this
can be avoided.
44. •Turn the camcorder’s power
off and on again, then
operate it.
45. •Do not subject the
camcorder to shock or
excessive vibration during
transport.
•Turn the camcorder on and
off. The lens cover closes.
TROUBLESHOOTING (cont.)