JVC RX-7030VBK - Manual (Page 89)

28
English
Setting the Speaker Distance
The distance from your listening point to the speakers is another
important element to obtain the best possible sound of the Surround
and DSP modes. Set the distance from your listening point to the
speakers.
By referring to the speaker distance setting, this unit automatically
sets the delay time of the sound through each speaker so that sounds
through all the speakers can reach you at the same time.
• If you have used Quick Speaker Setup on page 25, this setting is
not required.
7 Measuring unit—DIST UNIT
Select which measuring unit you use.
meter: Select to set the distance in meters.
feet: Select to set the distance in feet.
7 Speaker distance—FRONT DISTANCE, CNTR
DISTANCE, SURR DISTANCE, SBACK DISTANCE
Set the distance from the listening point within the range of
0.3 m (1 ft) to 9.0 m (30 ft), in 0.3 m (1 ft) intervals.
• When shipped from the factory, distance for each speaker is
set to “3.0 m (10 ft).”
Notes:
• You cannot set the speaker distance for the speakers you have
selected “NONE” (see page 27).
• This setting is not valid for the DVD MULTI playback mode.
Ex. In the above case, set the speaker distance as follows:
Front speakers: 3.0 m (10 ft)
Center speakers: 3.0 m (10 ft)
Surround speakers: 2.7 m (9 ft)
Surround back speakers: 2.4 m (8 ft)
Setting the Bass Sounds
You can adjust subwoofer and bass sounds precisely according to
your preference.
7 Subwoofer output—S WFR OUTPUT
You can select the type of the signal which can be transmitted
through the subwoofer. In other words, you can determine
whether or not the bass elements of the front speaker channels
are transmitted through the subwoofer regardless of the front
speaker size setting (either “SMALL” or “LARGE”).
Select one of the following:
LFE: Select to transmit only the LFE signals (while
playing Dolby Digital and DTS software) and
the bass elements of small speakers through the
subwoofer.
LFE+MAIN: Select to always add the bass elements of the
front speaker channels (MAIN) to the above
(LFE) setting, and to transmit them through the
subwoofer.
Note:
If you have selected “NO” for the subwoofer, this function is not
available.
7 Crossover frequency—CROSS OVER
When you use a subwoofer, you can select the cutoff frequency
for the small speakers used.
Select one of the crossover frequency levels according to the
size of the small speaker connected.
80Hz: Select when the cone speaker unit built in the speaker is
about 12 cm (4 3 / 4 inches).
100Hz: Select when the cone speaker unit built in the speaker is
about 10 cm (3 15 / 16 inches).
120Hz: Select when the cone speaker unit built in the speaker is
about 8 cm (3 3 / 16 inches).
150Hz: Select when the cone speaker unit built in the speaker is
about 6 cm (2 3 /
8
inches).
Notes:
.• If you have selected “LARGE” for all activated speakers (see
page 27), this function is fixed to “OFF.”
• Crossover frequency is not valid for the DVD MULTI playback,
All Channel Stereo, HEADPHONE, and 3D HEADPHONE
mode.
2.1 m
(7 ft)
2.4 m
(8 ft)
2.7 m
(9 ft)
3.0 m
(10 ft)
3.3 m
(11 ft)
C
L R
LS RS
LSB RSB
25-30_8030&7030[C]7.pm6 03.2.13, 2:52 PM 28