beautypg.com

Connecting the speakers – JVC RX-7030VBK User Manual

Page 11

background image

9

RIGHT

LEFT

RIGHT

LEFT

RIGHT

LEFT

+

RIGHT

LEFT

AM Antenna Connections

Turn the loop until you have the
best reception.

AM Loop Antenna
(supplied)

Snap the tabs on the loop into the slots
of the base to assemble the AM loop.

Outdoor single vinyl-covered wire (not supplied)

Notes:

• If the AM loop antenna wire is covered with vinyl, remove

the vinyl by twisting it as illustrated.

• Make sure the antenna conductors do not touch any

other terminals, connecting cords and power cord. This
could cause poor reception.

• If reception is poor, connect an outdoor single vinyl-covered wire

(not supplied) to the AM EXT terminal. (Keep the AM loop antenna
connected.)

Connecting the Speakers

You can connect the following speakers:
• Two pairs of front speakers to produce normal stereo sound.
• One pair of surround speakers to enjoy the surround effect.
• One surround back speaker or one pair of surround back speakers

to enjoy to produce more effective surround effect.

• One center speaker to emphasize human voices.
• One subwoofer to enhance the bass.

CAUTION:

Use only the speakers of the SPEAKER IMPEDANCE indicated by
the speaker terminals.
When connecting to both of the FRONT SPEAKERS 1 and 2

terminals, use speakers with an impedance of 16

Ω to 32 Ω.

When connecting to either the FRONT SPEAKERS 1 or 2

terminals, use speakers with an impedance of 8

Ω to 16 Ω.

Basic connecting procedure

1 Twist and remove the insulation at

the end of each speaker signal cable
(not supplied).

2 Open the speaker terminal.

RX-7030VBK/RX-7032VSL

(For FRONT SPEAKERS 2 terminals)

3 Insert the speaker signal cable.

4 Close the speaker terminal.

For each speaker (except for a subwoofer), connect the (+) and
(–) terminals on the rear panel to the (+) and (–) terminals
marked on the speakers.

Subwoofer

Speaker layout

Ideal speaker layout varies depending on the conditions of your
listening room. The diagram below is a recommended typical
example.

Left front speaker(s)

(L)

Right front speaker(s)

(R)

Center speaker

(C)

Surround back speakers (LSB/RSB)

Left surround

speaker (LS)

Right surround

speaker (RS)

+

RIGHT

LEFT

FM 75

COAXIAL

AM

EXT

AM

LOOP

ANTENNA

2

3

1

+

RIGHT

LEFT

01-16_8030&7030[J]10.pm6

03.2.13, 2:45 PM

9