JVC AV 32120 - Manual (Page 11)

10 key direct access
To move directly to a specific channel, press that channel's numbers on the remote's 10 key pad. For single-digit
channel numbers, press "0" then the channel number. For channels above 100, press the 100+ button, then the
remaining two digits on the 10 key pad.
C HANNEL -/+ BUTTON
To scan through the channels, press either the C H A N N E L + or C H A N N E L - button. You will move through the
channels in numerical ord e r.
• After you operate the Auto Tuner Setup (page 15), all of the empty channels will be removed from scanning.
When you scan you will only receive clear, active channels.
H y p e rs c a n
With JVC's Hyperscan feature you can zip through the channels at a rate of five per second. To use Hyperscan,
p ress and hold either the C
H A N N E L + or C H A N N E L - buttons. After the first few channels scan at normal speed, the
rest will move by at five per second. To scan at normal speed, press and release the C H A N N E L + / - b u t t o n .
Regular Return
P ress and release the R E T U R N + button to re t u rn to the previous channel viewed. For example, select a channel,
then select another channel using the 10 key pad buttons. You can now flip back and forth between these two
channels by pressing R
E T U R N +.
R
ETURN
+
With R E T U R N + Y ou can program your TV to always re t u rn to a specific channel. Press and hold down the R E T U R N +
button for three seconds. The message, "R E T U R N CHANNEL PROGRAMMED!" will appear on-screen. Now
when you scan through the channels, pressing R
E T U R N + will bring you back to your programmed channel.
To cancel the R E T U R N + channel, press and hold the R E T U R N + button for three seconds. The message "RETURN
CHANNEL CANCELLED!" will appear on-scre e n .
• Pressing any number key or turning off the TV will also cancel the R E T U R N + c h a n n e l .
• Press the P O W E R button on the remote control or the front panel of the TV. The ON TIMER lamp will glow red.
• Make sure the TV/CAT V switch on the remote is set to TV (RM-C381 and RM-C382 only). Move the switch to
C AT V only if you plan to operate a cable box. On the CATV setting the remote will only operate the cable box
f u n c t i o n s .
• To turn the power off, press the Power button again. The ON TIMER lamp will go out.
• The ON TIMER lamp will glow red when the On/Off Timer is set (page 24), even when the TV power is off.
Getting Started 11
1
2
3
4
POWER
To control the volume level, use the V O L U M E +/- b u t t o n s on the remote control or on the TV's front panel. Use
the V O L U M E - button to lower the volume. Press the V OLUME + button to raise the volume.
Press the M UTING button to instantly turn the volume to zero. Press M UTING again to return to the previous
volume level.
ADJUSTING VOLUME
CHANGING CHANNELS
VOLUME 13
|||||||
-------------------