JVC LCT2141-001A-H - Manual (Page 6)

6
1. Press select button corresponding to the item you
want to adjust.
The item you select is displayed on the screen.
1 PHASE ( ) : Phase control
2 CHROMA ( ) : Chroma control
3 BRIGHT ( ) : Brightness control
4 CONTRAST ( ) : Contrast control
2. Adjust with the VOLUME/SELECT buttons.
Items
VOLUME/SELECT button
– +
PHASE
(Phase)
reddish greenish
CHROMA
(Chroma)
lighter deeper
BRIGHT
(Brightness)
darker brighter
CONTRAST
(Contrast)
lower higher
* Screen indication will disappear about 10 seconds
after operating.
1. Press the POWER switch to turn on the power.
_ON : Power turns ON. (Power indicator: lit)
—OFF : Power turns OFF. (Power indicator: unlit)
2. Press the INPUT SELECT button to choose input.
Selects video/audio signals input to terminals on the rear
panel.
INPUT
SELECT
button
Terminals on the rear panel
Video signal input Audio signal input
1 Input A VIDEO A terminal AUDIO A terminal
2 Input B VIDEO B terminal AUDIO B terminal
3. Press the VOLUME/SELECT buttons to adjust the
speaker volume.
Press this button to display the speaker volume level on the
screen.
+ : The Built-in speaker volume is increased. (00
= 50)
– : The Built-in speaker volume is decreased. (50 = 00)
* Screen indication will disappear about 10 seconds after
operating.
PAL
VOLUME : 20
PHASE : 00
+ –
Colour system indication
(PAL or NTSC)
00 ~ 50
–20 ~ +20
HOW TO HANDLE BASIC
OPERATIONS
BASIC OPERATION
PICTURE ADJUSTMENT
With regard to Colour system indication
● With the COLOR SYSTEM setting
set to AUTO mode, when you turn on
the power or select inputs, the colour
system indication appears for about 3
seconds on the screen while PAL or
NTSC signals are being detected.
It does not appear when receiving
B/W signal or when no signal is input.
See page 7 for COLOR SYSTEM
setting.
Notes:
● Phase control is effective only in the
NTSC colour system mode.
● Chroma control is not effective when
receiving B/W or when no signal is
input.
● When the Chroma control is set
to level “–20”, the picture turns
monochrome.
● “NO EFFECT” is displayed (For
about 3 seconds) when your selected
function has no effect.
+ –
POWER
_ON
—OFF
INPUT SELECT
B A
1 2
VOLUME/SELECT
– +
1 2 3 4
PHASE CHROMA BRIGHT CONTRAST
VOLUME/SELECT
– +
02-15EN_TM-A14E_f.indd 6 02-15EN_TM-A14E_f.indd 6 06.6.9 3:13:31 PM 06.6.9 3:13:31 PM