JVC GVT0155-001A - Manual (Page 10)

7
Connections
7 AM (MW) loop antenna
Setting up supplied AM (MW) loop antenna
Connecting AM (MW) loop antenna
• Turn the loop antenna until you have the best reception during
AM (MW) broadcast program reception.
NOTE
• Make sure the antenna conductors do not touch any other terminals,
connecting cords and power cords. This could cause poor reception.
7 FM antenna
If reception is poor
NOTE
We recommend that you use coaxial cable for the FM antenna as it is
well-shielded against interference.
Connecting the FM and
AM (MW) antennas
coat, twist and pull the insulation coat off and
remove.
1
2
3
Antenna cord
Outdoor single vinyl-covered wire
antenna (not supplied)
AM (MW) loop
antenna
Center unit
Extend the supplied FM antenna
horizontally.
Center unit
FM antenna (supplied)
Outdoor FM antenna
(not supplied)
Outdoor FM antenna cord
(not supplied)
Center unit
Standard type (75 C
coaxial) connector
power cord until all other connections have been made.
THS33-11[B]-04start.fm Page 7 Monday, February 14, 2005 2:57 PM