JVC GR-DF428 - Manual (Page 38)

FEATURES FOR RECORDING 38
EN
MasterPage: Left
These effects let you make pro-style scene
transitions. Use them to spice up the transition
from one scene to the next.
Wipe or Fader works when video recording is
started or stopped.
1
Set the Power Switch to “M”.
2
Set “v” to the desired mode. ( ੬ pg. 27)
● The WIPE/FADER menu disappears and the
effect is reserved.
● The selected effect indicator appears.
3
Press the Recording Start/Stop Button to
activate the Fade-in/out or Wipe-in/out.
To deactivate the selected effect
Select “OFF” in step
2. The effect indicator
disappears.
NOTES:
● You can extend the length of a Wipe or Fader by
pressing and holding the Recording Start/Stop
Button.
● Some Wipe/Fader Effects cannot be used with
certain modes of Program AE with special effects.
(See the right column.) In this case, the selected
indicator blinks or goes out.
WIPE/FADER
OFF: Disables the function. (Factory-preset)
FADER–WHITE: Fade in or out with a white
screen.
FADER–BLACK: Fade in or out with a black
screen.
FADER–B.W: Fade in to a colour screen
from a black and white screen, or fade out from
colour to black and white.
WIPE–CORNER: Wipe in on a black screen
from the upper right to the lower left corner, or
wipe out from lower left to upper right, leaving a
black screen.
WIPE–WINDOW: The scene starts in the
centre of a black screen and wipes in toward the
corners, or comes in from the corners, gradually
wiping out to the centre.
WIPE–SLIDE: Wipe in from right to left, or
wipe out from left to right.
WIPE–DOOR: Wipe in as the two halves of
a black screen open to the left and right,
revealing the scene, or wipe out and the black
screen reappears from left and right to cover the
scene.
WIPE–SCROLL: The scene wipes in from
the bottom to the top of a black screen, or wipes
out from top to bottom, leaving a black screen.
WIPE–SHUTTER: Wipe in from the centre
of a black screen toward the top and bottom, or
wipe out from the top and bottom toward the
centre leaving a black screen.
1
Set the Power Switch to “M”.
2
Set “r” to the desired mode. ( ੬ pg. 27)
● The PROGRAM AE menu disappears and the
selected effect is activated.
● The selected effect indicator appears.
To deactivate the selected effect
Select “OFF” in step
2. The effect indicator
disappears.
NOTES:
● Some modes of Program AE with special effects
cannot be used during Night-Scope.
● When a subject is too bright or reflective, a vertical
streak may appear (smear phenomenon). Smear
phenomenon tends to occur when “SPORTS” or
any mode of “SHUTTER 1/250 – 1/4000” is
selected.
● Some modes of Program AE with special effects
cannot be used with certain Wipe/Fader effects.
(See the left column.) In this case, the selected
indicator blinks or goes out.
Wipe Or Fader Effects
Program AE With Special Effects
GR-DF428AH.book Page 38 Friday, March 18, 2005 5:07 PM