JVC GR-DF428 - Manual (Page 24)

VIDEO PLAYBACK 24
EN
MasterPage: Left
The Full-Function Remote Control Unit can
operate this camcorder from a distance as well
as the basic operations (Playback, Stop, Pause,
Fast-Forward and Rewind) of your VCR. It also
makes additional playback functions possible.
(
੬ pg. 25)
Installing The Battery
The remote control uses
one lithium battery
(CR2025).
1
Pull out the battery
holder by pushing the lock
tab.
2
Insert the battery in the
holder, and be sure to
have the “+” mark visible.
3
Slide the holder back in until you hear a click.
Beam Effective Area (indoor use)
When using the remote
control, be sure to point it
at the remote sensor.
The transmitted beam’s
approximate effective
distance for indoor use is
5 m.
NOTE:
The transmitted beam may not be effective or may
cause incorrect operation when the remote sensor
is directly exposed to sunlight or powerful lighting.
Buttons And Functions
A Infrared beam transmitting window
● Transmits the beam signal.
The following buttons are available only when
the camcorder’s Power Switch is set to “PLAY”.
B PAUSE Button
● Pauses the tape (੬ pg. 25)
Up Button ( ੬ pg. 26)
C SLOW Rewind Button (੬ pg. 25)
D REW Button
● Rewind/Reverse Shuttle Search on a tape
( ੬ pg. 22)
Left Button ( ੬ pg. 26)
E INSERT Button (੬ pg. 44)
F SHIFT Button (੬ pg. 26)
G DISPLAY Button (੬ pg. 23, 40)
H SLOW Forward Button (੬ pg. 25)
I PLAY Button
● Starts Playback of a tape (੬ pg. 22)
J FF Button
● Forward/Forward Shuttle Search on a tape
( ੬ pg. 22)
Right Button ( ੬ pg. 26)
K A. DUB Button (੬ pg. 43)
L STOP Button
● Stops the tape (੬ pg. 22)
Down Button ( ੬ pg. 26)
M EFFECT Button (੬ pg. 26)
N EFFECT ON/OFF Button (੬ pg. 26)
Playback Using The Remote
Control
1
1
2
3 3
Lock tab
Remote sensor
GR-DF428AH.book Page 24 Friday, March 18, 2005 5:07 PM