JVC KY-F1030 - Manual (Page 10)

E14
AC ADAPTER AA-P700
ON
OFF
POWER
AA-P700
AC
[IEEE1394]
[REMOTE]
[DC IN]
FOCUS LOCK
2. Before shooting
Connecting through digital output connector
The KY-F1030 can be remote-controlled from a personal computer, and the shot image can be
shown on the computer’s monitor.
Shooting with the camera when the flash is fired by the timing of an
external trigger switch.
1. Connect the KY-F1030’s [IEEE1394] connector to the IEEE1394 host adapter on the PC.
2. Connect the flash and trigger switch to the [REMOTE] terminal.
3. Turn on the power of the KY-F1030.
* The power for KY-F1030 can be supplied from the IEEE1394 connector of personal com-
puter. However, be sure to use the AC adapter (AA-P700) when using the motorized lens
or when using both analog output and digital output in combination.
4. Turn ON the PC, and then start up the special application software KY-LINK.
* For how to operate the application software, see the Help file of the KY-LINK.
Connect to the power supply
(
੬ page E18)
AC adapter
Attach lens
(
੬ page E17)
Connecting the IEEE 1394
Cable (
੬ page E18)
Flash
Trigger switch
Special application software
KY-LINK
PC
IEEE1394
host
adapter
CAUTION
● Do not turn the power switch on the AC adapter ON/OFF or unplug the IEEE1394 cable while the
application software is running.
● Before using the computer with the KY-F1030, release any settings that automatically set the com-
puter in the Stand by or Hibernate mode.
MEMO
If two or more KY-F1030 cameras are connected to one computer, it is not possible to view the camera
images simultaneously.
E15
AC ADAPTER AA-P700
ON
OFF
POWER
AA-P700
AC
[ANALOG OUT]
[DC IN]
FOCUS LOCK
Connecting through analog output connector
The image shot by the KY-F1030 can be shown on the computer’s monitor.
AC adapter
Connect the power supply
(
੬ page E18)
MEMO
When the shutter speed becomes slower (slower than 1/7.5s), the image may be seen interrupted.
Also, the image will not freeze even when the external trigger switch is pressed.
PC
Video
capture
board
Microscope
adapter
1. Connect the KY-F1030’s [ANALOG OUT] connector to the PC’s capture board.
2. Connect the AC adapter (AA-P700) to the KY-F1030, and then turn ON the power.
3. Turn ON the PC.
* For instructions on how to operate the video capture board or the employed application
software, see the respective instruction manual.
CAUTION
Use a 1/2-inch C-mount microscope adapter compatible with the microscope to be employed.