beautypg.com

Recording timer recording, Corrective action, Possible cause – JVC 0701MNV*ID*PJ User Manual

Page 59: Symptom

background image

EN

59

CORRECTIVE ACTION

Insert a cassette, or using adhesive
tape, reseal the slot where the tab
was removed.

Set to the desired channel.

Confirm that the source is properly
connected.

Confirm that all units' power switches
are turned on.
Set the input mode to "L-1", "F-1", "S-
1" or "S-2".

Confirm that the camcorder is
properly connected.
Set the input mode to "L-1", "F-1", "S-
1" or "S-2".

POSSIBLE CAUSE

● There is no cassette loaded, or the

cassette loaded has had its Record
Safety tab removed.

● "L-1", "F-1", "S-1" or "S-2" has been

selected as the input mode.

● The source (another video recorder,

camcorder) has not been properly
connected.

● All necessary power switches have

not been turned on.

● The input mode is not correct.

● The camcorder has not been

properly connected.

● The input mode is not correct.

SYMPTOM

1. Recording cannot be started.

2. TV broadcasts cannot be recorded.

3. Tape-to-tape editing is not possible.

4. Camcorder recording is not

possible.

CORRECTIVE ACTION

Re-perform the clock and/or timer
settings.
Press ‰

and confirm that "‰" is

displayed on the display panel.

Timer programming can't be
performed while a timer recording is
in progress. Wait until it finishes.

Load a cassette with the Record
Safety tab intact, or cover the hole
using adhesive tape.
Remove the cassette and cover the
hole with adhesive tape, or insert a
cassette with the Record Safety tab
intact.

Check the programmed data and re-
program as necessary, then press ‰

again.

The programme may not have been
recorded in its entirety. Next time make
sure you have enough time on the tape
to record the entire programme.

Refer to "G-

CODE/

S

HOW

V

IEW

System

Setup" and re-perform the procedure.
(

pg. 26)

SYMPTOM

1. Timer recording won't work.

2. On-screen timer programming is

not possible.

3. "‰" and "]" on the display panel

won't stop blinking.

4. "‰" blinks for 10 seconds and the

Timer mode is disengaged.

5. The power shuts off and "‰" and

"]" won't stop blinking.

6. The G-

CODE/

S

HOW

V

IEW

system does

not timer-record properly.

POSSIBLE CAUSE

● The clock and/or the timer have

been set incorrectly.

● The timer is not engaged.

● Timer recording is in progress.

● The timer is engaged but there's no

cassette loaded.

● The loaded cassette has had its

Record Safety tab removed.

● ‰

has been pressed when there are

no programs in memory, or the timer
record information has been
programmed incorrectly.

● The end of the tape was reached

during timer recording.

● The recorder's channel positions

have been set incorrectly.

RECORDING

TIMER RECORDING