JVC CA-MXDVA9 - Manual (Page 18)

– 15 –
Listening to FM and AM Broadcasts
Tuning into a Station
1
Press FM/AM.
The unit automatically turns on and
tunes into the previously received
station (either FM or AM).
• Each time you press the button, the
band alternates between FM and AM.
2
Start searching for stations.
On the unit:
Press and hold TUNING + or –
for more than 1 second.
On the remote control:
Press and hold + (
¡) or – (1)
for more than 1 second.
The unit starts searching for stations and
stops when a station of sufficient signal
strength is tuned in.
• If a program is broadcast in stereo, the ST (stereo)
indicator lights up.
To stop searching, press TUNING + or – (+ ( ¡) or
– (
1) on the remote control).
When you press TUNING + or – (+ ( ¡) or – (1) on
the remote control) briefly and repeatedly
The frequency changes step by step.
To change the FM reception mode
When an FM stereo broadcast is hard to receive or
noisy, press FM MODE while holding down
SHIFT on the remote control so that the MONO
indicator lights up on the display. Reception
improves.
To restore the stereo effect, press FM MODE
again while holding down SHIFT so that the
MONO indicator goes off from the display. In
stereo mode, you can hear stereo sounds when a
program is broadcasted.
Presetting Stations
You can preset 30 FM and 15 AM stations.
In some cases, test frequencies have been already memorized
for the tuner since the factory examined the tuner preset
function before shipment. This is not a malfunction. You can
preset the stations you want into memory by following the
presetting method.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 2
again.
On the unit ONLY:
1
Tune into the station you want to preset.
• See “Tuning into a Station.”
2
Press SET.
3
Turn PRESET + / – to select a
preset number.
4
Press SET.
The tuned station in step 1 is stored in the preset number
selected in step 3.
• Storing a new station on a used number erases the
previously stored one.
When you unplug the AC power cord or if a power
failure occurs
The preset stations will be erased in a few days. If this happens,
preset the stations again.
Tuning into a Preset Station
1
Press FM/AM.
The unit automatically turns on and
tunes into the previously received
station (either FM or AM).
• Each time you press the button, the
band alternates between FM and AM.
2
Select a preset number.
On the unit:
Turn PRESET + / –.
On the remote control:
Press the number buttons.
Ex.: For preset number 5, press 5.
For preset number 15, press
+10, then 5.
For preset number 20, press
+10, then 10.
For preset number 25, press
+10, +10, then 5.
For preset number 30, press
+10, +10, then 10.
+
EN11-15.CA-MXDVB10,B9,A9_f 02.4.24, 9:42 AM 15