JVC CA-MXDVA9 - Manual (Page 10)

– 7 –
1 Connect the AM loop antenna to the AM
LOOP terminals as illustrated.
• If the AM loop antenna wire is covered with
vinyl, remove the vinyl by twisting it as
shown in the diagram.
2 Turn the AM loop antenna until you have the
best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. The AM
loop antenna must remain connected.
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
AM antenna
Vinyl-covered wire
(not supplied)
AM loop antenna
(supplied)
COAXIAL
ANTENNA
AM LOOP
FM 75
AM EXT
1
2
Connecting Speakers
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
To connect main speakers and front subwoofers
SUBWOOFERS
MAIN
SPEAKERS
CAUTION: SPEAKER
IMPEDANCE
6
16
LEFT
LEFT
RIGHT
RIGHT
FRONT
Blue
1 3
Black
Red
Speaker cords
(blue/black)
Right front speaker Left front speaker
Speaker cords
(red/black)
Speaker cords
(red/black)
Black
2
1 Open the speaker terminal.
2 Insert the end of the speaker cord into the
terminal.
Match the polarity (colors) of the speaker terminals: Red
(+) to red (+) and black (–) to black (–); Blue (+) to blue
(+) and black (–) to black (–).
3 Close the speaker terminal.
• When using front multi speaker system, refer to
“Recommended Main Speakers and Subwoofers Layout”
separately attached.
EN01-10.CA-MXDVB10,B9,A9_f 02.4.24, 9:41 AM 7