Jacuzzi J - 375 - Manual (Page 22)

18
J-300 Series
8.0 spa Fill up procedure
For best results, read each step in its entirety before proceeding with that
step.
prepare The spa For Filling 1.
Clear all debris from the spa. (Although the spa shell has been •
polished at the factory, you may want to treat it with a specially
formulated spa cleaner.) Consult your authorized Jacuzzi dealer for
additional information prior to filling spa.
Remove filter cover, then remove filter cartridge as outlined in section
•
12.1 (page 30).
Fill spa 2.
Place the end of your garden hose into the empty filter bucket. •
CauTIon: To DeCrease BuIlD up on ComponenTs anD
mInImIZe aCrYlIC DamaGe.
Never fill with water from a water softener. If your water is extremely
“hard”, it is preferable to fill half-way with hard water and the rest of
the way with softened water. You may fill entirely with hard water if
you use a special water additive available from your Jacuzzi dealer.
!
•
warnInG:
To DeCrease rIsk oF InFeCTIon or
DIsease.
Fill hot tub with clean tap water from garden hose, to reduce risk of
contracting a waterborne illness (e.g. an infection, bacteria or virus)
and/or respiratory ailments. Fill until water covers all jets but does not
touch the bottom of the lowest headrest. (DO NOT OVERFILL!)
Turn on power 3.
Turn on power to spa at the home’s circuit breaker to start boot
up sequence (sec. 10.0, page 25). The heater and filter pump will
automatically activate after several seconds. If the control panel LED
flashes water temperature and “COL” or “ICE” this is normal, refer to
page 38 for additional information.
activate Jets pumps 4.
Turn on jets pump(s) to ensure proper mixing when adding
start-up chemicals in step 5.
add start-up Chemicals 5.
Add the spa water chemicals as recommended by your authorized
Jacuzzi dealer. See section 13.0 “Water Quality Maintenance” (page 36)
for general guidance.
18