JVC VN-V25U - Manual (Page 31)

31
6.
The top page of VN-V25U/26U appears
7.
The [Basic] page with the IP address settings appears when DHCP is not in use
A confirmation screen appears. Press the [OK] button. VN-V25U/26U restarts using the new IP
address. It takes about one minute for the camera to reboot.
Note:
● Access from this computer may fail when the IP address of VN-V25U/26U is changed. To enable
access to VN-V25U/26U from the same computer, alter the IP address at the computer accordingly.
Click on [Network], followed by [Basic]
on the next submenu.
A
B
C
Enter the values you wish to specify in
the [IP Address], [Subnet Mask] and
[Default Gateway] fields.
Click [OK].
Set the [IP Setting] item to [DHCP
Disable].
When the display or configuration of the opened screen appears strange, check
using the following procedures.
A
Click [Start] - [Control Panel] - [Display] and open the [Display Properties] window
B Click the [Settings] tab in the [Display Properties] windows and click the [Advanced] button
C Check that [DPI setting] in the [General] tab has become [Normal size(96DPI)]
D
Otherwise, change the setting to [Normal size(96DPI)] andreboot windows
VN-V25U_26U_EN.book Page 31 Monday, January 21, 2008 10:13 AM