Juniper Networks NETSCREEN 208 - Manual (Page 40)

Juniper Networks NetScreen Release Notes
ScreenOS 5.0.0r9-FIPS P/N 093-1638-000, Rev. A Page 40 of 42
• 28138 - The Websense server provides erroneous protocol version
information, which the Juniper Networks security appliance displays.
• 28016 - Juniper Networks security appliances do not support a MIP in the
same zone as the destination host.
W/A: Use policy-based destination NAT.
5.3.11 Known Issues from Previous Releases
• 27083 - When you enter the set service command to create a custom
service, the Juniper Networks security appliance does not check if you
entered valid source and destination port numbers.
• 25841 - When you configure RIP on the Juniper Networks security appliance
and enter the get config command, the output displays the set protocol
rip command twice. This is a display issue that does not affect the
performance of the device.