Juniper Networks NETSCREEN 208 - Manual (Page 18)

Juniper Networks NetScreen Release Notes
ScreenOS 5.0.0r9-FIPS P/N 093-1638-000, Rev. A Page 18 of 42
• 02655 – The event log timestamp changed to Daylight Savings Time (DST)
even though DST was not enabled.
• 02642 – After configuring SCREEN setting thresholds on a device using the
WebUI or CLI, the get config | include <screen_settings> command did
not display the configured settings.
• 02641 – The PKI IKE memory pool on a device had a memory leak caused by
the Security Manager agent.
• 02637 – A session allocation with less than 1,000 sessions on a Juniper
NetScreen-5000 Series device failed.
• 02629 – When running a get config all command and redirecting the output
to a file on the TFTP server when the Trust interface as the source, the file
was not transferred correctly.
• 02627 – The policy move page only displayed the first 20 policies, and
therefore you could not move a policy from the initial screen from where you
copied the beyond the 20 policies displayed.
• 02624 – An anti-virus scan failed to scan .RAR files on a Juniper
NetScreen-5GT.
• 02621 – When a Ping request is initiated through a VPN tunnel to a MIP
configuration on a loopback interface, the ICMP reply through the tunnel did
not get translated back to the MIP address.
• 02680 – The SNMP name command inappropriately propagated across the
NSRP cluster.
• 02682 – When using the WebUI to set information on the backup device, the
primary SNMP device was inappropriately deleted when using the unset
VSD ID 0.
• 02606 – A ping packet through a tunnel in an NSRP environment between
two Juniper Networks security appliances failed after a failover until you
performed a rekey operation.
• 02581 – You incorrectly could define the same IP address to multiple
loopback interfaces over multiple subnetworks by running the set vrouter
trust-vr ignore-subnet-conflict command on a device. Juniper Networks
security appliances support defining multiple loopback interfaces on the
same subnetwork, but not with duplicate IP addresses.
• 02578 – A PPPoE (Point-to-Point-Protocol-Over-Ethernet) connection on a
device incorrectly sent an acknowledgment for an unnumbered PPP session.
The correct response to an unnumbered PPP session is a NAK (Non-
Acknowledgment).
• 02552 – Policy authentication with an external authenticating server could
run into the same memory corruption when authentication failed and caused
the firewall to fail.