Juniper Networks NETSCREEN 208 - Manual (Page 9)

Juniper Networks NetScreen Release Notes
ScreenOS 5.0.0r9-FIPS P/N 093-1638-000, Rev. A Page 9 of 42
• 03132 – When using Juniper NetScreen-Remote to connect to a Juniper
NetScreen-500 dial-up VPN using the WebUI, the IKE Gateway
Configuration displays as user instead of user-group.
• 03128 – Mistakes occurred with (MIP) Mapped IP translation when a remote
shell used a secondary session initiated from the server for redirecting
standard error output from the console.
• 03095 – If the Juniper NetScreen-5XT autonegotiated its speed and duplex
settings with a Cisco 3550, the devices operated properly, but the connection
would fail if you manually set 100MBps - Full and 100MBps - Half for both
devices.
• 03092 – When the device was in transparent mode, it sometimes was unable
to download the latest anti-virus signatures.
• 03081 – An anti-virus parsing error slowed performance for HTTP sessions.
• 03078 – With a very large configuration, when you attempt to save a very
large configuration, the device sometimes generated false HA up-down
messages incorrectly indicating alternatively that the device disconnected
and connected.
• 03071 – If the first VIP (Virtual IP) in the VIP list did not have a service
defined for it, if you added a service to the second to fourth VIP in the list,
the VIP Summary Page displayed no data.
• 03068 – When you modified the IKE Phase 1 gateway name using the
WebUI, the primary device in an HA pair could not synchronize properly
with the backup device so that the backup device received the IKE gateway
name.
• 03058 – After you successfully updated a device with the latest configuration
in Security Manager, and then ran a Delta Configuration Summary
operation, the summary still displayed commands indicating that the update
did not successfully transfer all settings to the device.
• 03054 – The device did not update its ARP table because too many packets
queued up for the same ARP entry.
• 03042 – The serial interface on the device disappeared after you downgraded
from ScreenOS 5.0.0rx to a previous version with the Unlimited Number of
Users Version 2 key installed.
• 03025 – In certain situations, when a user authenticated using WebAUTH
with SecureID, and the user in the Auth table timed out, subsequent
attempts to authenticate failed.
• 03010 – In certain situations when you ping a Juniper NetScreen-5200-24FE
interface, an error condition occurred which sent out fragmented packets.
• 02988 – The ALG did not work for a custom-defined rsh (remote shell)
service.