Juniper Networks NETSCREEN 208 - Manual (Page 36)

Juniper Networks NetScreen Release Notes
ScreenOS 5.0.0r9-FIPS P/N 093-1638-000, Rev. A Page 36 of 42
• 36807, 36876 – When a 100Mbps link between a Juniper NetScreen-5000
Series system and another device reverts to a 10Mbps throughput level on
the other device, the Juniper NetScreen-5000 Series system remains at the
100Mbps throughput level when it should synchronize with the speed of the
connected device and revert to the lesser speed.
5.3.8 Known Issues from ScreenOS 5.0.0r3
None.
5.3.9 Known Issues from ScreenOS 5.0.0r2
• 35620 - (Juniper NetScreen-5GT only) If a policy is using a local address, any
modification to the netmask of the address produces a trace dump on the
console. This modification should not be a permitted action for the device.
• 36365 - In the WebUI, on the Traffic Log page for policies (under Reports),
the table displaying the information might disappear after viewing multiple
pages of traffic logs.
W/A: Refresh the Traffic Log page for policies by clicking the Refresh button
on your Internet Browser.
5.3.10 Known Issues from ScreenOS 5.0.0r1
• Documentation Correction - Page 3 of the What's New in NetScreen
ScreenOS 5.0 states incorrectly that Juniper Networks security appliances
support routing based on the source interface. The current implementation
does support routing based on source IP address.
• 36018 - (Juniper NetScreen-5GT only) The two month entitlement
expiration notice in the event log is triggering during the incorrect
timeframe. For example, if the AV entitlement expires in 52 day, the event
log indicates "License key av_key is about to expire in 2 months".
• 35582 - In an NSRP configuration, active/active or active-passive, if you
move a physical interface to a different zone on one device, you must
manually do the same on the other device because this type of change does
not get automatically synchronized.
• 35516 - In an active-passive NSRP configuration, when you load a PKA key
onto the master device, the master does not automatically synchronize the
backup device.
W/A: Manually synchronize the two devices.
• 35439 - (Juniper NetScreen-5GT only) Within the WebUI, identical routes
are displayed on multiple pages. When the number of routing table entries