JVC CA-MD9R - Manual (Page 9)

5
English
Connecting the Speakers
For each speaker, connect one end of the speaker wire to the speaker terminals on the back of the
CA-MD9R and the other end to the speaker.
1. Open the terminals and insert the speaker wires firmly (be sure to remove the insulation at the
ends of each wire first), then close the terminals.
2. Connect the red (+) and black (–) terminals of the right side speaker to the red (+) and black (–)
terminals marked RIGHT on the CA-MD9R.
Connect the red (+) and black (–) terminals of the left side speaker to the red (+) and black (–)
terminals marked LEFT on the CA-MD9R.
CAUTION: Make all connections before plugging the unit into an AC power outlet.
LEFT RIGHT
SPEAKERS
Right speaker Main Unit Left speaker
IMPORTANT: Use speakers with the correct impedance only. The correct impedance is indicated on
the back panel.
CAUTION: If a TV is installed near the speakers, the picture on the TV may be distorted. If this
happens, place the speakers away from the TV.
Connecting an External Component
You can connect another component to the AUX jacks, and reproduce the sound of the
component through the CA-MD9R.
Note: When you connect a VCR to the CA-MD9R, connect the VCR and the TV directly using
the video cords to watch a video tape or record a TV program.
(Refer to instructions for speakers as well.)
AUX
LEFT
RIGHT
To the audio output jacks
VCR (or another component)
EN.01-24.CA-MD9R[E]/F 6/16/98, 1:48 PM 5