JVC CA-MD9R - Manual (Page 38)

34
English
Standard Recording
To record any source currently playing use the following procedure.
❏ You can also record the same source on the tape at the same time. (See page 55 for tape
recording.)
1.
Insert a blank or recordable MD into one of the MD loading slots.
2.
Press the MD button (1 to 3) (or the DISC button (1 to 3) on the Remote Control) corresponding to
the slot number you put the MD, then press the
7 button.
3.
Choose and start playing the source you want to record (CD, Tuner, Cassette Deck or the
external component).
4.
Press the REC PAUSE button on the MD Recorder.
The indicator on the button lights up.
5.
Press the ‹ / 8 button to start the recording.
❏ If some tracks have been recorded on the MD, this MD Recorder searches for the end point of
the previous recording, and starts recording after the end point.
To pause any time during recording process, press the
‹ / 8 button (or the REC PAUSE button on
the Remote Control). The track mark will be recorded.
To cancel the pause, press the
‹ / 8 button again (or the £ on the Remote Control).
To stop recording, press the 7 button.
Changing the Display Mode —————————————————————
You can check the remaining time of the MD while recording.
Press and hold the DISPLAY/CHARA button on the unit. While you are holding the button, the
remaining time of the MD will be shown on the display (as well as the source name you are
recording).
CD
STEREO TUNED
MD
1 2 3 4 5
3
2
1
2
1
3
MD
REC PAUSE
MD 3
MD
2
MD
1
/
DISPLAY
/CHARA
/
EN.25-40.CA-MD9R[E]/F 6/16/98, 1:50 PM 34