JVC CA-MD9R - Manual (Page 20)

16
English
EON Function ——————————————————————————
The EON function allows the unit to switch temporarily to a broadcast program of your choice
(NEWS, TA, and/or INFO) from a different station except when you are listening to a non-RDS
stations (all AM (MW/LW) and some FM stations).
❏ The EON indicator lights up while receiving a station with the EON code.
❏ EON Standby reception is applicable for preset stations only.
To set EON Standby reception, use the Remote Control:
1.
Press the RDS CONTROL button.
The number buttons on the Remote Control are set for the RDS operations.
2.
Press the EON ON/OFF button.
The last EON data type selected — TA/NEWS/INFO — lights up.
3.
Press the TA/NEWS/INFO button repeatedly until the EON data type you want is selected.
TA:
Identifies that a traffic announcement is being broadcast in your area.
NEWS: News
INFO:
Program the purpose of which is to impart advice in the widest sense.
Each time you press the TA/NEWS/INFO button, the EON data types change as follows:
TA NEWS INFO = TA NEWS INFO = TA NEWS INFO =
TA NEWS INFO = TA NEWS INFO = TA NEWS INFO =
TA NEWS INFO =
(back to the beginning)
As soon as your selection is entered, the unit goes into EON Standby reception mode.
To cancel the EON function, press the EON ON/OFF button again so that the TA/NEWS/INFO
indicator goes off.
❏ If you cancel the EON function while receiving a program selected by the EON function, the
unit goes back to the previously tuned station.
When this unit carries out EON Standby reception, this unit functions as follows:
4
TA/NEWS/
INFO
RDS
CONTROL
1
EON ON/OFF
CASE 1
If there is no station broadcasting the program
you have selected
The unit continues tuning in the current station.
«
When a station starts broadcasting the program
you have selected, the unit automatically
switches to the station. The indicator of
received PTY code starts flashing.
«
When the program is over, the unit goes back
to the previously tuned station, but still
remains in EON Standby reception mode.
CASE 2
If there is a station broadcasting the program
you have selected
The unit tunes in the program. The indicator of
received PTY code starts flashing.
«
When the program is over, the unit goes back
to the previously tuned station, but still
remains in EON Standby reception mode.
EN.01-24.CA-MD9R[E]/F 6/16/98, 1:49 PM 16