IBM 09N4076 - Manual (Page 27)

1 Headphone jack
This jack provides audio output to the headphones.
2 Volume control
This dial controls the headphone volume.
3 CD tray
This tray is where you load and unload a CD.
4 Busy indicator
This light comes on when the drive reads from, writes to, or plays a CD.
5 Manual-eject hole
This hole provides access to the eject mechanism to remove a CD from the drive.
6 Eject/Load button
This button opens and closes the CD tray when you push it.
Back view of the drive
Refer to the following illustration to identify parts that might be referred to in the
installation instructions.
1 Reserved
2 Audio-out connector
This port connects the CD-RW drive to a sound adapter.
3 Configuration pins
These pins are used to set the drive configuration.
4 IDE connector
This port connects the CD-RW drive to the IDE cable.
5 DC-power connector
This port connects the CD-RW drive to the computer power supply cord.
Installing the drive
Follow these steps to install the CD-RW drive into your computer.
Part 1: Installation and usage guide 1-19