IBM 09N4076 - Manual (Page 19)

Do not write on the surface.
Do not place the CD in direct sunlight.
Do not use commercial cleaners to clean the CD.
Do not bend the CD.
Caring for the CD-RW drive
To protect your CD-RW drive during operation, observe the following precautions.
Remove any CD in the drive before moving the drive.
Do not insert foreign objects into the drive.
Do not stack objects on the drive.
Do not remove the drive cover or attempt to service the drive.
Do not operate the drive under any of the following conditions:
– High temperature, high humidity, or direct sunlight
– Excessive vibration, sudden shock, or inclined surface
– Excessive dust
Loading a CD
To load a CD into a horizontally mounted CD-RW drive, follow these steps.
1. Press the Eject/Load button. The tray slides out of the drive.
2. Insert the CD into the loading tray with the label facing up.
3. Close the loading tray by pressing the Eject/Load button, or by gently pushing the
tray in.
Attention: Do not force the tray to open; do not insert foreign objects into the
CD tray. If your tray does not open when you press the Eject/Load button, see
“Manually ejecting a CD” on page 1-13 for information on manual ejection.
Part 1: Installation and usage guide 1-11