Intel ECB-870 - Manual (Page 71)

ECB-870
ECB-870 User’s Manual 59
4.5.5.9 Onboard FDC Controller
Select “Enabled” to activate the on-board FDC and “Disabled” to activate an add-on FDC.
The choice: Disable, Enable.
4.5.5.10 Onboard Serial Port 1 & 2
Select an address and corresponding interrupt for the first/second serial port. The default
value for the first serial port is “3F8/IRQ4” and the second serial port is “2F8/IRQ3”.
The choice: Disable, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 3F8/IRQ3, and Auto.
4.5.5.11 UART Mode Select
Select to activate the Infrared transfer function.
The choice: IrDA, ASKIR, Normal.
4.5.5.12 RxD , TxD Active
This choice: Hi, Lo; Lo, Hi; Lo, Lo; Hi, Hi.
4.5.5.13 IR Transmission Delay
If this option is enabled, transmission of data will be slower. This is recommended when
you encounter transmission problem with your device.
The choice: Disable, Enable.
4.5.5.14 UR2 Duplex Mode
Select to activate the Infrared transfer function. This default setting is “Half“.
The choice: Full, Half.
4.5.5.15 Use IR Pin
When you select to IrDA or ASKIR mode, you can define use (TX,RX ) pin.
The choice: RxD2, TxD2; IR-Rx2Tx2.
4.5.5.16 Onboard Parallel Port
Select address and interrupt for the Parallel port.
The choice: Disable, 378/IRQ7, 278/IRQ5, and 3CB/IRQ7.
4.5.5.17 Parallel Port Mode
Select an operating mode for the parallel port.
The choice: SPP, EPP, ECP, ECP+EPP, and Normal.