Impex MD-823 - Manual (Page 8)

ASSEMBLY INSTRUCTION
Tools required for assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches.
NOTE: It is strongly recommended that two or more people assemble this machine to
avoid possible injury.
STEP 1 (See Diagram 1)
A.)
Do not tighten Nuts and Bolts until instructed to do so.
B.) Attach the Left Upright Beam (#1) to a Rear Base Frame (#14). Secure it with one M10 x 4 ½”
Allen Bolt (#62), one Ø ¾” Washer (#70), and one M10 Aircraft Nut (#68).
C.) Attach Left Diagonal Support (#15) to Left Upright Beam and the Rear Base. Secure each end
with one M10 x 3” Allen Bolt (#60), two Ø ¾” Washers (#70), and one M10 Aircraft Nut (#68).
D.) Repeat B & C above to install Right Upright Beam (#2), Right Diagonal Support (#16), and the
other Rear Base together.
E.) Connect the Left and Right Upright Beams with a Cross Brace (#3) in the mid-span. Secure
each end with two M10 x 4 ¾” Carriage Bolts (#66), one 4 ¾” x 2” Bracket (#26), two Ø ¾”
Washers (#70), and two M10 Aircraft Nuts (#68).
DIAGRAM 1
7