Impex MD-823 - Manual (Page 12)

STEP 5 (See Diagram 5)
A.) Attach the Backrest Board (#31) to the Backrest Supports (#13). Secure it with four M8 x 1
5/8” Allen Bolts (#55) and four Ø 5/8” Washers (#69).
B.) Attach the Seat Pad (#30) to the Seat Supports (#11). Secure it with four M8 x 1 5/8” Allen
Bolts (#55) and four Ø 5/8” Washers (#69).
C.) Attach the Arm Curl Pad (#32) to the Arm Curl Stand (#9). Secure it with two M8 x 5/8”
Allen Bolts (#54) and two Ø 5/8” Washers (#69). Insert the Arm Stand into the opening on
Leg Developer Holder (#5). Use the Lock Knob (#51) to lock the Stand in position.
D.) Attach six Foam Rolls (#44) to the Long Foam Tube (#29) and the two Foam Tubes (#28).
Plug six Foam Roll End Caps (#41) into the ends of the Tubes.
E.) Attach three Olympic Sleeves (#53) to the two Weight Posts (#24) and the Leg Developer
Weight Pos (#25). Attach a Spring Clip (#45) to each Olympic Sleeve.
F.) Attach the Left & Right Squat Bar Catch (#17 & #18) into selected holes on Left & Right
Upright Beam (#1 & #2).
G.) Attach the Left & Right Bar Catch (#19 & #20), Left & Right Safety Catch (#21 & #22) to
selected holes on Left & Right Upright Beam.
DIAGRAM 5
11