IBM xSeries 330 User Manual
Page 74
66
Hardware Maintenance Manual: xSeries 330
Keyboard connector:
There is one keyboard connector on the end of the device
breakout cable. This connector is identified by the keyboard icon.
Note:
If you attach a standard (non-USB) keyboard to the keyboard connector, the
USB ports and devices will be disabled during the power-on self-test (POST).
The following table shows the pin-number assignments for the keyboard connector
on the end of the cable.
Video connector:
The following table shows the pin-number assignments for the 15-
pin analog video connector on the end of the C2T device breakout cable. This cable is
not labeled but is easily identified by the dark blue 15-pin connector.
Auxiliary-device (pointing device) connector:
On the end of the C2T device
breakout cable, there is one auxiliary-device connector that supports a mouse or other
pointing device. This connector is identified by the mouse icon.
Table 12. Keyboard-connector (6-pin female) number assignments .
Pin
I/O
Signal
1
I/O
Data
2
N/A
Reserved
3
N/A
Ground
4
N/A
+5 V dc
5
I/O
Keyboard clock
6
N/A
Reserved
Table 13. Video-connector (15-pin female) number assignments.
Pin
Signal
Pin
Signal
Pin
Signal
1
Red
6
Ground
11
Not connected
2
Green or monochrome
7
Ground
12
DDC SDA
3
Blue
8
Ground
13
Horizontal synchronization
(Hsync)
4
Not connected
9
+5 V dc
DDC
14
Vertical synchronization (Vsync)
5
Ground
10
Ground
15
DDC SCL
6
4
2
1
3
5
1
5
11
15