IBM xSeries 330 - Manual (Page 31)

Chapter 3. Diagnostics 23
Ethernet teaming messages:
0x0F Explanation: Could not allocate enough memory for other structures. Action:
1. From the Windows NT desktop, select Start -> Control Panel -> Networks -> Adapters.
2. Select your IBM Ethernet adapter from the list.
3. Select Properties -> Advanced.
4. Lower the value for the resource named in the message.
0x10 Explanation: Did not find any Ethernet controllers. Action: Using the Configuration/Setup utility,
make sure that Ethernet is enabled.
0x11 Explanation: Multiple Ethernet controllers found, but none matched the required ID. Action:
Using the Configuration/Setup utility, make sure that Ethernet is enabled.
0x13 Explanation: Did not find any Ethernet controllers that matched the required subven/subdev.
Action: Using the Configuration/Setup utility, make sure that Ethernet is enabled.
0x16 Explanation: Single adapter found but multiple instances tried to load. Action: Using the
Configuration/Setup utility, make sure that Ethernet is enabled, and that the slot containing the
IBM Netfinity 10/100 Ethernet Adapter or the IBM 10/100 Etherjet PCI adapter is enabled.
0x17 Explanation: Slot parameter not specified in the registry. Action: Remove the adapter driver and
reinstall it. If the problem persists, call for service.
All other 4-
character
hexadecimal
codes Action: Call for service.
Table 7. NDIS (Windows NT or Windows 2000) driver teaming messages for the Ethernet controller.
Event ID Type Description
01 Error Explanation: Team Name and physical adapter name are the same. This is
an invalid configuration. Action: Reconfigure the adapter team by double-
clicking the PROSet icon in the control panel.
02 Error Explanation: Unable to allocate required resources. Action: Free some
memory resources and restart.
03 Error Explanation: Unable to read required registry parameters. Action:
Reconfigure the adapter team by double-clicking the PROSet icon in the
control panel.
04 Error Explanation: Unable to bind to physical adapter. Action: Reconfigure the
adapter team by double-clicking the PROSet icon in the control panel.
05 Error Explanation: Unable to initialize an adapter team. Action: Reconfigure the
adapter team by double-clicking the PROSet icon in the control panel.
06 Informational Explanation: Team nn. Primary adapter is initialized. Action: None.
07 Informational Explanation: Team nn. Secondary adapter is initialized. Action: None.
08 Informational Explanation: Team nn. Virtual adapter or Team is initialized. Action: None.
09 Informational Explanation: Team nn. Primary adapter is switching over. Action: None.
10 Warning Explanation: Team nn. Adapter link down. Action: Make sure the adapter
is functioning properly.
11 Informational Explanation: Team nn. Secondary adapter took over. Action: None.
Table 6. NDIS (Windows NT or Windows 2000) driver messages for the Ethernet controller.
Error code (hex) Description