Invacare Auriga10 - Manual (Page 55)

55
Did the old inner tube get wet during repair?
In case the old inner tube is to be repaired and used again, and it gets wet during repair, then it
is easier to re-fit it if you powder it lightly with talcum powder.
•
Place the rim halves in the tyre from the outside.
•
Pump up the tyre a little.
•
Re-position the screws and nuts that hold the rim together and tighten them firmly.
•
Check to make sure that the tyre is squarely in place on the rim.
•
Pump up the tyre to the recommended tyre pressure (2.5 bar, or 40 psi).
•
Check to make sure that the tyre is still squarely and snugly in place on the rim.
•
Screw the valve cap back on.
•
Refit the wheel.