Chapter 2. installation instructions, Chapter 2, “installation instructions – IBM SUREMARK TI8 User Manual
Page 39
![background image](/manuals/128746/39/background.png)
Chapter 2. Installation instructions
. . . . . . . . . . . . . . . . . . . . . . 18
Installing a SureMark printer . . . . . . . . . . . . . . . . . . . . 18
Installing for EIA-232/RS-485 communication . . . . . . . . . . . . . 18
Installing SureMark for USB communication . . . . . . . . . . . . . 21
Using the wall mounting feature. . . . . . . . . . . . . . . . . . . 23
Installing the fillers
. . . . . . . . . . . . . . . . . . . . . . . 24
Installing fillers for EIA-232/RS-485 printers . . . . . . . . . . . . . 24
Installing fillers for USB printers . . . . . . . . . . . . . . . . . . 26
EIA-232 communication mode selections (all models except TI8, TI9, TG8, TG9) 28
DTR/DSR control . . . . . . . . . . . . . . . . . . . . . . 29
XON/XOFF control
. . . . . . . . . . . . . . . . . . . . . 29
EIA-232 communication mode selections (Models TI8, TI9, TG8, TG9) . . . . 30
DTR/DSR control . . . . . . . . . . . . . . . . . . . . . . 30
XON/XOFF control
. . . . . . . . . . . . . . . . . . . . . 30
. . . . . . . . . . . . . . . . . . . . 31
USB selection . . . . . . . . . . . . . . . . . . . . . . . . . 31
Before installing an IBM SureMark printer, be sure to read “Electronic emission
notices” on page 205.
DANGER
To avoid a shock hazard, do not connect or disconnect any cables
or perform installation, maintenance, or reconfiguration of this
product during an electrical storm.
DANGER
To avoid shock hazard:
The power cord must be connected to a proper ly wired and
earthed receptacle.
Any equipment to which this product will be attached must also
be connected to properly wired receptacles.
Note: For translations of these safety notices, see IBM Safety Information—Read
This First, GA27-4004.
Updated April 2, 2009
© Copyright IBM Corp. 1997, 2006
17