Icom IC-M422 - Manual (Page 41)

35
9
CONNECTIONS AND MAINTENANCE
8
9
■ Connections
q DC POWER CONNECTOR
Connects the supplied DC power cable from this connector
to an external 12 V battery.
w EXTERNAL SPEAKER LEAD (Yellow)
Connects to an external speaker or hailer speaker.
e PUBLIC ADDRESS LEAD (Blue)
Connects to an external speaker or hailer speaker.
• PA output power: 4.5 W (typical) at 10% distortion
with a 4 Ω load
r NMEA IN LEAD (Red)
Connects to a GPS receiver for position indication.
• A NMEA0183 ver. 2.0 or 3.01 (sentence formatters RMC, GGA,
GNS, GLL) compatible GPS receiver is required. Ask your dealer
about suitable GPS receivers.
t NMEA OUT LEAD (White)
Connects to a PC or navigation equipment (NMEA0183
ver. 3.01 sentence formatters DSC, DSE compatible) for
plotting position data received from other ships.
y ANTENNA CONNECTOR
Connects a marine VHF antenna with a PL-259 connector
to the transceiver.
CAUTION: Transmitting without an antenna may dam-
age the transceiver.
u EXTERNAL MICROPHONE JACK
Connects to optional HM-157 COMMANDMIC II ™.
CAUTION: After connecting the DC power cable, NMEA
IN/OUT leads, external speaker lead and public address
lead, cover the connector and leads with an adhesive tape
as shown below, to prevent water seeping into the trans-
ceiver.
Rubber vulcanizing
tape
u
q
y
w
e
r
t
!IC-M422.qxd 05.2.23 2:21 PM Page 35 (1,1)